You are here: Balver Zinn Englisch Pfeil Alloys Pfeil Solder wires Pfeil LF 2220 NC

Balver Zinn solder wire LF2220 NC

BALVER ZINN SOLDER WIRE LF2220 NC has been developed for lead-free rework and touch-up of lead-free circuitry. The well-balanced flux activation system leaves minimal non-corrosive residues. BALVER ZINN SOLDER WIRE LF2220 NC provides fast wetting of critical surfaces to form strong joints. With a higher specific heat requirement than tin-lead solder, 20% more energy is needed to heat the soldering tip to 370°C. BALVER ZINN SOLDER WIRE LF2220 NC is also „no-clean“ and halide-free. The standard flux content is 2.2 % and flux residues may remain on the board without cleaning. BALVER ZINN SOLDER WIRE LF2220 NC is offered in diameters from 0.3mm to 3.5mm and is also available in lead-free alloys SN100C, SN96C and SN97C. Lead-containing wires or special alloys are available on request. SN96C and SN97C are in accordance to J-STD-006B! For additional information please refer to the product data sheet.

Physical and chemical properties

Acid value:
J-STD-004; IPC-TM-650, Method 2.3.13; 06/04 A
212 mg KOH/g ± 5%
Copper mirror test:
J-STD-004; IPC-TM-650, Method 2.3.32; 06/04 D
L
Silver chromate test:
J-STD-004; IPC-TM-650, Method 2.3.33; 06/04 D
passed
Solid content, flux:
J-STD-004; IPC-TM-650, Method 2.3.34; 06/04 C
n.d.
Bromide und Chloride Test:
J-STD-004; IPC-TM-650, Method 2.3.35; 06/04 C
n.d.
Fluoride after spot test:
J-STD-004; IPC-TM-650, Method 2.3.35.1; 06/04 A
passed
Insulation resistance:
J-STD-004; IPC-TM-650, Method 2.6.3.3; 06/04 B
> 1x10 E8 Ohm
Corrosion test:
J-STD-004; IPC-TM-650, Method 2.6.15; 06/04 C
passed

Delivery sizes

Parameter Standard
Wire diameter (mm) 0,3 /0,5 / 0,8 / 1,0 / 1,5 / 2,0 / 2,5 / 3,0 / 3,5
Flux content
(weight-%)
2,2

Other diameters, flux contents and features on request.

Reels

Weight 0,25 / 0,4 kg 0,5 / 1,0 kg 0,4 / 0,8 kg
Marking 63/37 BZ K80
Height 63 mm 80 mm 80 mm
Outside diameter 63 mm 76 mm 80 mm
Inside diameter 11 mm 30 mm 16 mm
Reels./carton 10 10 10